 |
MIDI Solutions Breath Controller
The MIDI Solutions Breath Controller accepts the BC3A as input and generates continuous MIDI data corresponding to the amount of breath pressure applied to it. The Breath Controller will also accept input from older Yamaha BC1 and BC2 units. It converts the voltage from the Yamaha BC3A Breath Controller to continuous MIDI data and can be inserted inline anywhere in the MIDI data stream. You can also use it between a MIDI keyboard and a sound module to add control of various parameters such as volume, modulation, aftertouch, etc. (the message type is programmable to most types of MIDI messages). Just like a pedal controller, you can set up the Breath Controller to control a specific System Exclusive parameter. This enables you to control synth parameters that cannot be controlled by MIDI controller messages. The Breath Controller allows you to send a System Exclusive message with a single variable byte, determined by the amount of breath pressure applied to the unit. These messages can be sent to synths that allow certain parameters to be controlled via sysex only, enabling you to experiment with sounds in ways that were not previously possible. It has a MIDI Echo parameter you can select as on/off. When MIDI Echo is on, all MIDI messages appearing at the MIDI In of the Breath Controller are echoed to its MIDI Out. When MIDI Echo is off, messages appearing at the MIDI In of the Breath Controller are filtered,...
|
